I got bored and decided that I would get a Rasp Pi 3, the official Kodi Raspberry Pi Case and install OpenELEC on it. This is a cheap and easy way to make your own Kodi device. Granted, it’s not powerful but if you are a casual user who only uses it for one specific activity then this could be something that is of interest to you.
What you will need:
Raspberry Pi
Power Source for Pi
Micro SD Card (16GB+)
Micro SD Card Adaptor
Latest version of OpenELEC for RPi
HDMI Cable
USB Keyboard or remote control with wireless dongle (you can get these dirt cheap on eBay or Amazon.
Download the latest version of OE for whichever model your Pi is. The latest version can be found here
Now open the .img.gz file that has just downloaded by double clicking it and let your Mac extract the files – Extract to Downloads
Place your Micro SD in the Micro SD Adaptor and place it in your Mac
Open Terminal
Type diskutil list and you should see an output similar to this
We now need to unmount the Micro SD. You obviously need to know which your SD card is – it will probably be /dev/disk2 but you can easily look at the output for the section marked size and take an educated guess at whether the size shown on there is approximately the same size as your SD card
To unmount type the following – Remember, if it isn’t disk2 then change it to the correct disk number
diskutil unmountDisk /dev/disk2
You should now see the following message
Unmount of all volumes on disk2 was successful
Now we want to erase the card so type the following (remember to change disk2 to the number of your disk)
sudo dd if=/dev/zero of=/dev/disk2 bs=512 count=1
As we are using sudo you will need to enter your Mac password (please be careful and ensure the disk number is correct). You should see an output like this
Earlier in the guide you extracted the necessary files from the .img.gz file and if you did what I said then it will be in your downloads folder
Now we want to install those files on the Micro SD card so type the following
sudo dd if=/Users/mjd/Downloads/OpenELEC-RPi2.arm-7.0.1.img of=/dev/disk2 bs=1m
Take a look at the output closely as you will need to make changes to suit your setup. /Users/mjd/Downloads needs to be changed to your user path /Users/YourUsername/Downloads check in your downloads folder to find the name of the .img file the latest is OpenELEC-RPi2.arm-7.0.1.img if your is different then change it to that and /dev/disk2 must be changed to /dev/disk# replacing # with the number of the disk you unmounted earlier in the guide. As we are using sudo you may be asked your Mac password again, enter it if necessary. You may need to wait a couple of minutes for the files to transfer now
When the files are transferred you should now see an input similar to this
OE is now installed on your Micro SD card and can be safely ejected from your Mac
You now need to connect your USB keyboard or remote control with wireless dongle attached to the RPi otherwise you can’t do anything. You also need to connect your RPi to your TV or monitor with the HDMI cable
Now you just need to remove the Micro SD from the adaptor and place it into the Micro SD slot on your RPi and OE will install. It will then take you to the OpenELEC wizard. With the keyboard attached you can just follow the wizard and have Kodi up and running in no time.
Check out my other Kodi posts; you’ll find plenty to improve your Kodi experience
Get 25% off any VPN Plan with IPVanish VPN, using promo code SEOM
Access all Kodi add-ons
Access geo-restricted content from anywhere
Encrypt and anonymise your Kodi traffic
No logs of your traffic
Kill Switch: Kills network if VPN connection is lost
Prevent ISP throttling
۷ day money back guarantee
IPVanish
خرید وی پی ان آنتی فیلترآنتی فیلتر